WATER BASED

MCC 5116 is a floor coating for RCC surfaces requiring a high degree of dirt repellence, washability and superior resistance to bio-organism based on water based PUD. It can be used for interior and exterior applications. MCC 5116 is fast curing, tough, flexible, better scratch resistance properties . The coated floor will attain a good re-coatability and non-absorbent features.

Metcon MCC 5116 is applicable over prepared and cleaned RCC surfaces. The coating fulfils 100% low VOC compliance required for clean room applications. The coat is also ideally suited for laboratories, pharma and Terrace waterproofing applications .

Metcon MCC 5116 Wall coat is applicable by brush/roller . 2nd coat may be applied if required for floor sealing purposes. After 2 hrs drying.

6 - 8 Sq.mtrs/ltr in 1 coat approximately for finished surfaces. For porous concrete water thinning is advisable for purpose of capillary filling and sealing.

• Priming coat with MCC 5101 Metcon Tough coat Primer for Masonry walls.
• 2 coat Application of MCC 5115 water based PUD in pigmented finish for masonry walls.

• Ensure that masonary surfaces are adequately finished in plumb and level.
• Crevices and cracks should be sealed with Polycem MCC 1240 Polymer and cement sealer and sanded properly. Crack sealing with MCC-1240 with cement and silica flour gives excellent sealing.
• Acrylic wall putty or spray plaster may be applied in 1 or 2 layer as may be required for uniform appearance for interior finish.
• The ready surface should be primed using Metcon MCC 5101 tough coat primer.
• For best results do not excessively thin the paint.
• Clean the spray equipment with water immediately after use. This will prevent clogging of nozzles.

• Care should be taken during usage and storage to avoid splashes and contact with eyes, mouth, skin & food stuffs.
• Treat splashes to eyes & skin immediately with fresh flowing water. If swallowed, seek medical help immediately.
• Use protective eye goggles, hand gloves and dust/ vapour masks while using the product
• Use adequate ventilation while using the coatings. Appropriate spray booth enclosure should be provided for spray finish.
• Provide dust-resistant environment for Polyurethane coatings.