Whats New

EPOXY INJECTABLE GROUT MIX (MCC -1357)

PRODUCT DESCRIPTION

MCC 1357 is injectable material based on Epoxy polyamide for grouting holes and cracks on concrete and walls. Being solventless formulation it cures fast and becomes strong. The low viscous nature gives long lasting adhesion to the surfaces under operation. It is spray able and hence may be used on substrates other than concrete. The application can be done with special type gun available.

RECOMMENDED USAGE

MCC 1357 is useful for new or old concrete and wall joints or repairs to provide seamless, strong and rigid bonding between surfaces. It can also be used for other substrates or metal for same purpose.

DIRECTIONS TO USE

It is necessary to clean the surface to be bonded with suitable equipment or liquid. Mix base and hardener in the ratio 2:1 by volume and make the mixture homogenous. If necessary suitable mineral aggregates are to be mixed with and applied as per the job requirement. Application may be done with brush, paltipatra, special gun available. The cured material is corrosion and abrasion resistant, dust free and shrinkage free.

TECHNICAL SPECIFICATION

Type : Epoxy – Polyamine based
Shade : Yellowish clear
% Solids : 100%
Finish : Glossy
Mixing Ratio : 1:1 (by volume)
Flash Point : Above 100oC
Pot life : 45 - 50 minutes at 30oC
Drying Time : Surface dry : 4 – 5 hours
Tack free dry : 8 - 10 hours
Hard dry : 24 hours
Recommended DFT : 1 or 2 mm (as per requirement)
Induction period : 10–15 mins
Clean up : Epoxy thinner
Shelf life : 12 months in unopened containers
Safety Precautions : This product is intended for use only by professional applicators. Use of personal protective equipment and adequate ventilation is recommended during application